Pipe ready for Welding

After sourcing a suitable length of pipe with
the correct bore I cut a section with angled ends
to extend the end can of the left pipe to clear the
swingarm. The end can will be extended by about
70mm. The original internal stinger has been cut
to be welded in place where it would normally be
with the other end with the silencer being able to
fit back into the end can. The stabilizer strap will
have to be remade to span across the 3 sections
of pipe.

The images below show the pipes taped up to give
an impression of the layout/run of the pipe. [its a bit saggy!]